Bionaire BEF6500 Instruction Manual download pdf (Page 4)

Heater cycles on and off frequently

1. The thermostat automatically turns the heater on

and off to maintain selected comfort level.

2. To make this occur less frequently adjust the

thermostat setting up or down.

FOR U.K. AND IRELAND ONLY

If the plug is not suitable for the socket outlets

in your home, it can be removed and replaced

by a plug of the correct type. Please refer to

“Installation of a plug” below.

Installation of a plug applicable to U.K.

and Ireland

NOTE: If the terminals in the plug are not

marked or if you are unsure or in doubt about the

installation of the plug please contact a qualified

electrician.

If a 13A 3-pin plug is fitted, it must be an ASTA

approved plug, conforming to BS1363 standard.

Replacement 13A fuses must be BSI or

ASTABS1362 approved.

This product is fitted with a 13A plug complying to

BS1363. If this plug is unsuitable or needs to be

replaced, please note the following: The wires in

the mains lead are coloured as such:

BROWN - LIVE

BLUE - NEUTRAL

Please note that the colour of these mains wires

may not correspond with the colour markings that

identify the terminals in your plug. Please proceed

as follows:

The BROWN coloured wire must be connected to

the terminal, which is marked with the letter “L” or

is coloured RED.

The BLUE coloured wire must be connected to

the terminal, which is marked with the letter “N” or

is coloured BLACK.

DO NOT CONNECT either of these wires to the

earth terminal in the plug. The earth terminal plug

is marked with the letter “E”, or with the earth

symbol

, or coloured GREEN, or GREEN and

YELLOW.

GUARANTEE

Please keep your receipt as this will be required

for any claims under this guarantee.

This appliance is guaranteed for 2 years after

your purchase as described in this document.

During this guaranteed period, if in the unlikely

event the appliance no longer functions due to

a design or manufacturing fault, please take

it back to the place of purchase, with your till

receipt and a copy of this guarantee.

The rights and benefits under this guarantee

are additional to your statutory rights, which are

not affected by this guarantee. Only Holmes

Products (Europe) Ltd. (“Holmes”) has the right

to change these terms.

Holmes undertakes within the guarantee period

to repair or replace the appliance, or any part of

appliance found to be not working properly free

of charge provided that:

• you promptly notify the place of purchase

or Holmes of the problem; and

• the appliance has not been altered in any

way or subjected to damage, misuse,

abuse, repair or alteration by a person

other than a person authorised by Holmes.

Faults that occur through, improper use, damage,

abuse, use with incorrect voltage, acts of

nature, events beyond the control of Holmes,

repair or alteration by a person other than a

person authorised by Holmes or failure to follow

instructions for use are not covered by this

guarantee. Additionally, normal wear and tear,

including, but not limited to, minor discoloration

and scratches are not covered by this guarantee.

The rights under this guarantee shall only apply

to the original purchaser and shall not extend to

commercial or communal use.

If your appliance includes a country-specific

guarantee or warranty insert please refer to

the terms and conditions of such guarantee

or warranty in place of this guarantee or

contact your local authorized dealer for more

information.

This marking indicates that this product should

not be disposed with other household wastes and

should be disposed separately throughout the

EU. To prevent possible harm to

the environment or human health

from uncontrolled waste disposal

due to the presence of hazardous

substances within the product,

recycle it responsibly to promote

the sustainable reuse of materials

and resources. To return your used

device, please use the return and

collection systems available to you or contact the

retailer where the product was purchased. They can

take this product for environmentally safe recycling.

Holmes Products (Europe) Limited

1 Francis Grove

London

SW19 4DT

4. To switch the digital thermostat mode off,

press the digital thermostat button until the

LEDs on digital thermostat setting on the

control panel or remote are no longer lit.

TIMER

Note: Timer will work only if one of the three

mode settings is used.

1. Press the digital timer button (L) on the

control panel or remote enough times to

activate one of the 6 preset desired OFF

times (2,4,6,8,10 or 12Hrs)

2. The timer will now turn the unit completely off

based on the selected OFF time.

3. To switch the digital timer mode off, press

the digital timer button until the LEDs on

timer setting on the control panel or remote

are no longer lit.

FLAME INTENSITY

There are five flame brightness settings, ranging

from a low to high setting and then OFF. Press

flame intensity button (M) on the control panel or

remote control to select desired intensity. Please

note that this function works on all modes and is

also fully independent.

AUTO SAFETY SHUT OFF

This heater is equipped with a technologically

advanced safety system that automatically shuts

off the current to the heater when a potential

overheat temperature is reached. The heater

can resume operation only when you reset it and

after it has cooled down.

RESET INSTRUCTIONS

If the unit shuts down:

1. Turn main unit ON/OFF Switch to position (

)

(see Fig. 2, N)

2. Unplug unit, wait 30 minutes

3. Plug in the unit

4. Turn main unit ON/OFF Switch to position

(–) (see Fig. 2, N)

5. Select desired mode and setting following

operating instructions.

BULB REPLACEMENT

1. Turn off and unplug the unit from the power

socket.

2. Leave the unit to stand for 5 minutes so that

the bulb can cool down.

3. Remove the front glass panel to a safe place.

4. Empty the pebbles from the unit.

5. Unscrew the light bulb access panel (C)

using a cross head screwdriver, being careful

not to lose the screws.

6. Pull out the bulb.

7. Replace the G9 Type bulb with the same

type with a 40W max rating.

8. Screw back the light bulb access panel,

replace the pebbles and front glass and plug

the unit into the power socket for operation.

Note: The G9 Type bulb should be readily

available from most hardware stores. If not

please contact the manufacturer for further

assistance.

CLEANING AND MAINTENANCE

• Always unplug the heater before cleaning and

allow to cool.

• To clean glass use household glass cleaner.

• Lightly run a vacuum cleaner nozzle over the

heater vent to remove any dust or dirt that

may have accumulated.

• Carefully wipe the heater with a soft, damp

cloth. Please be very cautious near the

heating elements.

• After cleaning, be sure to completely dry the

heater with a cloth or towel before switching on.

• Store your heater in a cool, dry location.

TROUBLESHOOTING

Flame not bright enough

1. Regulate flame brightness using the flame

intensity button.

2. Check bulb is working and replace if

necessary.

Simulated fire will not illuminate

1. Check power.

2. Press the flame intensity button.

3. Check bulb and replace if necessary.

Unit making crackling/popping sound

1. This is normal; when the unit is first used or

has not been used for a while this sound is

caused by dust buildup burning away.

2. Please refer to Cleaning and Maintenance

section for prevention.

Heater will not turn off

1. Refer to operating instructions.

Heater blows cool air

1. This is normal when the unit is on the fan

only setting.

2. Press the mode control until you select the

LOW (1) or HIGH (2) heat setting.

Remote does not work

1. Check the ON/OFF switch on the main unit is

in the ON position.

2. Change batteries (See Assembly Instructions).

3. Be sure to point remote at the main unit.

4. Be sure there are no obstructions between

remote and unit.

Not enough heat

1. Increase thermostat setting to highest setting.

2. This is a 2000 watt heater and is intended for

supplementary heat only.

1 2 3 4

Comments to this Manuals

No comments

Bionaire BEF6500 Instruction Manual Page 4

Comments to this Manuals

Related products and manuals for Fireplaces Bionaire BEF6500