Bionaire BAP1700 Instruction Manual download pdf (Page 5)

AIR QUALITY PARTICLE SENSOR

The AUTO feature uses the particle sensor to cycle

between 1, 2 and 3 speeds, based on surrounding

indoor air quality. To use this feature:

1. When air purifier is off, press the AUTO button.

 

turn on to auto mode.

2. When air purifier is on and set at any manual

mode speed, press the “auto” button.

 

run in auto mode.

SETTING THE TIMER MODE

You may set the timer so it automatically turns off

when the desired time has elapsed:

 

) button until you reach the

desired number of hours you want the unit to



 

remain illuminated on the control panel.

  

times and turn off.

 

until TIMER indicator lights are off. You may also

cancel the timer operation by turning the power

button off.

CLEANING AND

MAINTENANCE

CLEANING THE PERMANENT FILTERS





cleaning for optimal performance.

 

filters.

 



filters before further use.

To clean the filter:

1. Turn off and unplug the air purifier.

 

 

  

it in warm soapy water. Rinse and drip dry

thoroughly before placing it back into the gril inlet.

 



 

  

attachment along both sides of the filters and

 

IMPORTANT: Do not use water, household cleaners

or detergents to clean the PERMANENT filters.

The filter may appear discolored, even after

vacuuming. This is normal and does not affect

performance in any way—a new filter is not

necessary. If the filter becomes damaged during

cleaning, visit the nearest Authorized Service

Center to purchase a replacement filter.

RESETTING THE FILTER INDICATOR LIGHT

AND REINSTALLING THE FILTERS



the filter indicator light.

NOTE: A hang tab and filter clips ensure the filters

attach properly.

1. Unplug unit from wall.

2. Make sure the hang

tab is securely in place

 

clip on the top of the

filters with the rails on

the side of the of the unit

 

 



foam pre-filter) back

onto unit securely.

4. After replacing the filters,

completely close the unit

and plug it into the wall

outlet.

5. With the unit on, RESET

 

)

by inserting a small

 

paper clip) into the hole

below the Filter Indicator

  ).



for 5 seconds.

7. The light will now turn off.

Figure 2

Figure 3

Figure 4

Figure 5

Reset

Button

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

Bionaire BAP1700 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Air purifiers Bionaire BAP1700